DTC P0496: EVAP System High Purge Flow Detected
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review GENERAL TROUBLESHOOTING INFORMATION
.
- Turn the ignition switch ON (II).
- Clear the DTC with the HDS.
- Do the EVAP FUNCTION TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the FTP sensor, the EVAP canister purge valve, the EVAP canister vent shut valve, and the PCM.
NO - Go to step 4.
- Turn the ignition switch to LOCK (0).
- Replace the EVAP canister purge valve (see EVAP CANISTER VENT SHUT VALVE REPLACEMENT ).
- Turn the ignition switch ON (II).
- Reset the PCM with the HDS.
- Do PCM IDLE LEARN PROCEDURE .
- Do the EVAP FUNCTION TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES - Troubleshooting is complete.
NO - Check for poor connections or loose terminals at the FTP sensor, the EVAP canister purge valve, the EVAP canister vent shut valve, and the PCM, then go to step 1.