FixVault
Home › Honda › 2011 › Insight Base › Repair and Diagnosis › Engine Mechanical › Cooling System (Mechanical) › Cooling System › Connecting Pipe Replacement

Connecting Pipe Replacement

  1. Drain the engine coolant (see COOLANT CHECK  ).
  2. Remove the thermostat housing (see THERMOSTAT REPLACEMENT  ).
  3. Remove the connecting pipe (A).
    Fig 1: Identifying Connecting Pipe With O-Ring
    G06429107Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the connecting pipe with a new O-ring (B).
  5. Install the thermostat housing (see INSTALLATION  ).
  6. Refill the radiator with engine coolant, and bleed the air from the cooling system (see step  9 ).
  7. Clean up any spilled engine coolant.
About FixVault