Switch Test/Replacement

NOTE: SRS components are located in the area. Review the SRS component locations (see COMPONENT LOCATION INDEX , and precautions and procedures (see PRECAUTIONS AND PROCEDURES before doing repairs or servicing.

Remove the driver's seat (see FRONT SEAT REMOVAL/INSTALLATION
Separate the lumbar support switch cover (A) from the switch (B).

Fig 1: Identifying Lumbar Support Switch Cover And Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 5P connector (C) from the switch.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Terminal Position Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the switch.