FixVault
Home › Honda › 2012 › CR-Z Base, Standard Trans › Repair and Diagnosis › Accessories & Equipment › Infotainment › Navigation System › DTC Troubleshooting › DTC 1307: DVD Read Error

DTC 1307: DVD Read Error

NOTE:
  • Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
  • This navigation DTC sets when the navigation DVD is severely scratched or dirty, or if the audio-navigation unit's DVD drive is malfunctioning.
  • Make sure the correct navigation DVD version is installed.
  • Before you troubleshoot, make sure to follow the General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION  ).
  • Check any official Honda service website for more information about the navigation system and software updates.
  1. Check the navigation DVD.

    Is the navigation DVD the correct color and version for the vehicle? Is it scratch free? 

    YES  -Go to step  2.

    NO  -Replace the navigation DVD, and recheck.

  2. Turn the ignition switch to ON (II).

    Is there a DVD error message? 

    YES  -Go to DVD screen error messages (see ERROR MESSAGE TABLE  ).

    NO  -Go to step  3.

  3. Clear the hard error code (see HOW TO CLEAR ERROR HISTORY  ).
  4. Turn the ignition switch to LOCK (0), and then back to ON (II).
  5. Check for the hard error code (see HOW TO CHECK ERROR HISTORY (NAVIGATION DTCS)  ).

    Is DTC 1307 indicated? 

    YES  -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION  ).

    NO  -Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION  ).

About FixVault