VSA OFF Switch Test

WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to LOCK (0).
Open the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
Push out the VSA OFF switch (A) from the driver's dashboard lower cover.

Fig 1: Identifying VSA OFF Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the VSA OFF switch 5P connector terminal in each switch position according to the table.

Fig 2: Checking Continuity Between VSA OFF Switch 5P Connector Terminal
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Identifying Switch Terminal Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between VSA OFF switch 5P connector terminals No. 4 and No. 5. There should be continuity at all times.

Fig 4: Checking Continuity Between VSA OFF Switch 5P Connector Terminals No. 4 & No. 5
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, remove the cover (A), and replace the bulb (B).

Fig 5: Identifying Cover & Bulb
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the VSA OFF switch in the reverse order of removal.