FixVault
Home › Honda › 2012 › Insight Base › Repair and Diagnosis › Body & Frame › Door Locks › Keyless/Power Door Locks/Security System › Door Lock Knob Switch Test › Driver's Door

Driver's Door

  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 10P connector (A) from the door latch (B).
    Fig 1: Identifying Driver's Door Latch 10P Connector Terminals
    G08094614Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.
    • There should be continuity between terminals No. 6 and No. 5 when the door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.
    • There should be continuity between terminals No. 7 and No. 5 when the door lock knob switch is in the UNLOCK position and no continuity when the switch is in the LOCK position.
    • Check for continuity between terminals No. 6 and No. 7 of door lock knob switch. There should be no continuity in either the LOCK or UNLOCK positions.
  4. If the continuity is not as specified, the switch is faulty; replace the driver's door latch (see FRONT DOOR LATCH REPLACEMENT ).
About FixVault