Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Remove the passenger's dashboard undercover (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
2. Open the glove box.
3. Disconnect the glove box damper (A) from the pivot (B) on the glove box.
   Fig 1: Identifying Glove Box Damper And Pivot

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Close the glove box.
5. Remove the bolts.
   Fig 2: Glove Box Bolts With Torque Specifications

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them in, then remove the glove box.
   Fig 3: Identifying Glove Box And Glove Box Stops

   Courtesy of AMERICAN HONDA MOTOR CO., INC.

   Glove box damper removal 

7. If necessary, from the glove box opening, detach the clip (A), then remove the glove box damper (B).
   Fig 4: Identifying Glove Box Damper And Clip

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Install the glove box in the reverse order of removal, and push the clip into place securely.