FixVault
Home › Honda › 2012 › Insight Base › Repair and Diagnosis › External Pages › Different car › Section 2 (IMA System) › IMA Motor Housing Removal/Installation

IMA Motor Housing Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the IMA motor rotor (see IMA MOTOR ROTOR REMOVAL/INSTALLATION  ).
  2. Remove the connector (A) and the bracket (B).
    Fig 1: Bolt With Torque Specifications, Connector, Bracket And IMA Motor Housing
    G06429997Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the bolt (C) and the IMA motor housing (D).
    NOTE: Set the dowel pins (E) in the IMA motor housing before installing the motor stator on the engine.
  4. Install the parts in the reverse order of removal.
  5. Install the IMA motor rotor (see IMA MOTOR ROTOR REMOVAL/INSTALLATION  ).
  6. Do the motor rotor position calibration procedure (see IMA MOTOR ROTOR POSITION CALIBRATION  ).
About FixVault