Driver's Seat Position Sensor Replacement: Installation

NOTE:

Be sure to install the harness so it does not pinched or interfere with other parts.
Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

Install the driver's seat position sensor (A) with a new TORX bolt (B), using a TORX T30 bit.

Fig 1: Driver's Seat Position Sensor, Torx Bolt And Subharness 2P Connector With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the driver's seat position sensor subharness 2P connector (C) to the driver's seat position sensor.
Install the outer recline cover (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION ).
Do the 12 volt battery terminal reconnection procedure (see RECONNECTION ).
Clear any DTCs with the HDS (see HOW TO CLEAR DTCS ).
Check the operation of the driver's seat position sensor with the HDS (see DRIVER'S SEAT POSITION SENSOR OPERATION CHECK ).
Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.