SRS Unit Replacement: Removal

Do the 12 volt battery terminal disconnection procedure (see USING THE GR8 BATTERY DIAGNOSTIC STATION ), then wait at least 3 minutes before starting work.
Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
Remove the heater joint duct (see step 7 DASHBOARD/STEERING HANGER BEAM REMOVAL/INSTALLATION ).
Disconnect SRS unit connectors (A) from the SRS unit.
NOTE: The SRS unit connectors have lever locks. Release the locks before disconnecting the connectors (see LEVER-LOCKED CONNECTOR ).

Fig 1: Identifying SRS Unit Connectors And Torx Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the TORX bolts (B) using a TORX T30 bit, then pull out the SRS unit.