Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX)
, and the precautions and procedures (see PRECAUTIONS AND PROCEDURES
) before doing repairs or servicing.

Remove the front seat (see FRONT SEAT REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the lumbar support motor.

Fig 1: Identifying 2P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test motor by applying battery voltage and body ground to the terminals.

Fig 2: Terminals Position Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the motor does not run or fails to run smoothly, replace the lumber support actuator (see FRONT SEAT LUMBAR SUPPORT REPLACEMENT ).