Center Console Disassembly/Reassembly

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the Honda Tool and Equipment Program; call 888-424-6857

1. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
2. Remove the console armrest (see CONSOLE ARMREST REMOVAL/INSTALLATION ).
3. While pushing the beverage holder lever (A), slide the beverage holder (B) forward, and disengage the beverage holder stops (C) to remove the beverage holder.
   Fig 1: Sliding Beverage Holder

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. If necessary, remove the TORX screws with a TORX T20 bit, then separate the beverage holder housing (A) and the beverage holder base (B), then remove the beverage holder retainer (C).
   Fig 2: Identifying Beverage Holder Housing/Base & Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Release the console lid (A).
   Fig 3: Identifying Console Lid (A)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the TORX screws with a TORX T20 bit, then separate the console (A) and the console frame (B).
   Fig 4: Identifying Console (A), Console Frame (B) & Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Remove the TORX screws with a TORX T20 bit, then separate the console box (A) and the console frame (B). Disconnect the console box light bulb socket (C), remove the piece of tape (D), and detach the connector clip (E), then remove the console box light (F) and the AC power outlet (G) (for some models) from the console box.
   Fig 5: Identifying Console (A), Console Frame (B), Light Bulb Socket (C), AC Power Outlet (G) & Fasteners

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Remove the console lid bumpers (H). Release the hooks (I), then remove the console lid guides (J) from the console frame.
9. Reassemble the console in the reverse order of disassembly, and note these items:

• Make sure the light bulb socket is plugged in properly.
• Replace the removed tape with new one.
• Push the hooks into place securely.