M/T model

Remove the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
Remove the driver's dashboard lower cover (see FUSE LID PANEL REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the clutch pedal position switch A.

Fig 1: Identifying Clutch Pedal Position Switch With Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals according to the table.
- If the continuity is not as specified, replace the clutch pedal position switch A (see CLUTCH PEDAL POSITION SWITCH REPLACEMENT ), and adjust the pedal height (see CLUTCH PEDAL AND CLUTCH PEDAL POSITION SWITCH ADJUSTMENT ).
- If OK, connect the clutch pedal position switch A 2P connector.
  
  Fig 2: Clutch Pedal Position Switch Connector Terminals Continuity Chart
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the driver's dashboard lower cover (see FUSE LID PANEL REMOVAL/INSTALLATION ).
Install the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).