FixVault
Home › Honda › 2014 › Crosstour EX-L, 2.4L Eng › Repair and Diagnosis › External Pages › Different car › Section 83 (Driver Position Memory System (DPMS) (V6)) › Driving Position Memory Switch Test/Replacement

Driving Position Memory Switch Test/Replacement

WARNING: This page is about a different car, the 2012 Honda Accord, 2011 Honda Accord, 2010 Honda Accord, 2009 Honda Accord, and 2008 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's door panel.
  2. Disconnect the 7P connector (A) from the driver's position memory switch (B).
    Fig 1: Identifying Driver's Position Memory Switch 7P Connector Terminals
    G07352497Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the four screws, then remove the switch from the door panel.
  4. Check for continuity between the terminals in each switch position according to the table.
    NOTE:
    • Make sure the correct test lead (+ or -) is placed on the terminal.
    • When checking for continuity across the diode, use the diode setting ($$) on the digital volt/ohm meter to check the diode bias.
    • Be careful of this characteristic; a diode conducts fully in one direction (forward), and not at all in the opposite direction (reverse).
    Fig 2: Terminals Continuity Chart
    G07352498Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the continuity is not as specified, replace the switch.
  6. Install the switch in the reverse order of removal.
About FixVault