FixVault
Home › Honda › 2014 › Fit › Repair and Diagnosis › External Pages › Different car › Section 10 (Engine Cooling System) › Water Pump Inspection

Water Pump Inspection

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right front wheel.
  2. Remove the splash shield.
  3. Loosen the water pump pulley mounting bolts (A).
    Fig 1: Identifying Water Pump Pulley And Mounting Bolts
    G00504551Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the drive belt (see DRIVE BELT REMOVAL/INSTALLATION ).
  5. Remove the water pump bolts and pulley (B).
  6. Turn the water pump counterclockwise, and make sure that it turns freely. If it does not, replace the water pump (see WATER PUMP REPLACEMENT  ).
    NOTE: When checking the water pump, you may see a small amount of "weeping" from the bleed holes (A). This is normal.
    Fig 2: Identifying Bleed Holes
    G05952714Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the water pump pulley (A), and loosely install the water pump pulley mounting bolts (B).
    Fig 3: Water Pump Pulley And Mounting Bolts With Torque Specifications
    G00504552Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Install the drive belt (see DRIVE BELT REMOVAL/INSTALLATION ).
  9. Tighten the water pump pulley mounting bolts.
    Fig 4: Water Pump Pulley Mounting Bolts With Torque Specifications
    G05952713Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Install the splash shield.
  11. Install the right front wheel.
About FixVault