Washer Motor Test
WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the right inner fender (see FRONT INNER FENDER REPLACEMENT ).
- Disconnect the 2P connector (A) from the washer motor (B).
- Test the motor by connecting battery power to the terminal No. 1 (or No. 2), and ground to terminal No. 2 (or No. 1) of the washer motor. The motor should run.
- If the motor does not run, or fails to run smoothly, replace it.
- If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.