For some models

NOTE:

Take care not to scratch the center console.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
Gently pull out the center console rear trim (A) to detach the hooks (B) and the clip.

Fig 1: Identifying Center Console Rear Trim, Hooks And Clip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws (A, B), then remove the center console armrest (C).

Fig 2: Identifying Screws And Center Console Armrest
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Console box replacement
If equipped, disconnect the USB unit connector (A), detach the harness clips (B), and remove the screws, then remove the console box (C).

Fig 3: Identifying USB Unit Connector, Harness Clips, Screws And Console Box
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the armrest in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the USB unit connector is plugged in properly.