FixVault

Rear Controller and Screen Connector For Inputs and Outputs

WARNING: This page is about a different car, the 2011 Honda Pilot, 2010 Honda Pilot, and 2009 Honda Pilot. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Controller & Screen Connector For Inputs & Outputs
G05967030Courtesy of AMERICAN HONDA MOTOR CO., INC.
WIRE COLOR REFERENCE TABLE

Cavity Wire Color Connect to
1 WHT No. 23 (10 A) fuse in the under-hood fuse/relay box (+B)
3 BLK Audio unit (GA-NET RR BUS+)
5 BRN Audio unit (RR NTSC GND)
6 RED Audio unit (HP R/LGND)
7 BRN(1) Shield for terminals No. 6, No. 18, and No. 19 (HP R/L SH)
10 LT GRN Audio unit (SCTY3)
11 LT BLU No. 14 (7.5 A) fuse in the under-dash fuse/relay box (ILL+)
12 YEL Audio unit (SYS ACC)
13 BRN(1) Shield for terminals No. 3 and No. 14 (GA-NET RR BUS SH)
14 WHT Audio unit (GA-NET RR BUS-)
16 YEL Audio unit (RR NTSC)
17 BRN(1) Shield for terminals No. 5 and No. 16 (RR NTSC SH)
18 WHT Audio unit (HP L)
19 BLK Audio unit (HP R)
22 RED Navigation display unit (SCTY2)
23 YEL Dash lights brightness controller
24 BLK Body ground to G404 (GND)
(1) The shielded wires have a heat-shrunk tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.