Tweeter and Test

From the notch (A), carefully pry the tweeter grille (B) out of the dashboard with a small screwdriver. Be careful not to damage the tweeter grille and the dashboard.

Fig 1: Identifying Notch, Tweeter Grille And 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 2P connector (C) from the tweeter.
Remove the tweeter (A) from the speaker grille by prying at the hook (B).

Fig 2: Identifying Tweeter And Hook
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Measure the resistance between the tweeter (A) terminals as shown.
- With navigation and rear entertainment: Measure the resistance between the tweeter 2P connector terminals No. 1 and No. 2. There should be about 3.3 Ω.
- With navigation, without rear entertainment or without navigation: Measure the resistance between the terminal No. 2 and the outside terminal of the capacitor (B). There should be about 6 Ω. Also check the capacitor condition. If any problem is found, replace the tweeter.
With navigation and rear entertainment

Fig 3: Measuring Resistance Between Tweeter Terminals (With Navigation And Rear Entertainment)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

With navigation, without rear entertainment or without navigation

Fig 4: Measuring Resistance Between Tweeter Terminals (With Navigation, Without Rear Entertainment Or Without Navigation)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the resistance is not as specified, replace the tweeter.