Back Window Middle Glass Regulator Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Put on gloves to protect your hands.
Take care not to bend or scratch the trim or the panels.

Remove these items:
- Rear seat assembly (see REAR SEAT REMOVAL/INSTALLATION )
- C-pillar trim, both sides (see C-PILLAR TRIM )
- Rear seat belt lower anchor (see REAR SEAT BELT REPLACEMENT )
- Rear seat side trim, both sides (see TRIM REMOVAL/INSTALLATION - DOOR AREAS )
- Subwoofer for some models (see SUBWOOFER )
- Rear panel insulator (see REAR PANEL INSULATOR REPLACEMENT )
Remove the back window middle glass mounting bolts.

Fig 1: Back Window Middle Glass Mounting Bolts With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the connector (A) from the regulator motor (B).

Fig 2: Regulator Motor Connector, Bolts, Cable Clips And Regulator With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the bolts (C, D), and detach the cable clips (E), then remove the regulator (F) and motor.
Apply multipurpose grease to the sliding surfaces of the regulator (A) where shown.

Fig 3: Identifying Grease Applying Area On Sliding Surfaces Of Regulator
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the regulator in the reverse order of removal, and note these items:

Slide the glass right and left to make sure it moves freely without binding.
Make sure the connector is plugged in properly.