DTC P0716 (6-Speed A/T)

DTC P0716  : Input Shaft (Mainshaft) Speed Sensor (Range/Performance)

NOTE: 

• Before you troubleshoot, review the General Troubleshooting Information - Refer to: How to Troubleshoot the A/T System .
• This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

DTC (A/T)

1. DTC check

   - 1. Turn the vehicle to the ON mode.

   - 2. Clear the DTC with the HDS.

   - 3. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.

   - 4. Start the engine.

   - 5. Disable the VSA by pressing the VSA OFF button.

   NOTE: Enter the VSA maintenance mode in case of the vehicle speed above 31 mph (50 km/h).

   - 6. Run the vehicle with the shift lever in D, and keep the vehicle speed at speeds over 12 mph (20 km/h) for at least 10 seconds. Slow down, and stop the wheels.

   - 7. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0718 Input Shaft (Mainshaft) Speed Sensor (Intermittent Failure)

   Is DTC P0718 indicated?

   YES 

   Do the troubleshooting for DTC P0718 .

   NO 

   Go to step 2.

2. Problem verification

   - 1. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0716 Input Shaft (Mainshaft) Speed Sensor (Range/Performance)

   Is DTC P0716 indicated?

   YES 

   The failure is duplicated. Go to step 3.

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

3. Input shaft (mainshaft) speed sensor connection check

   - 1. Check the input shaft (mainshaft) speed sensor for poor connection and proper installation.

   Is the connection and installation OK?

   YES 

   The connection and installation are OK. Replace the input shaft (mainshaft) speed sensor .

   NO 

   Repair faulty connection or installation.