How to Enter VSA System Maintenance Mode: Procedure
- Maintenance Mode - Enter
NOTE: - Entering condition of VSA Maintenance Mode - Refer to: VSA System Description - VSA Control, or VSA System Description - Brake Assist Control, or VSA System Description - ABS Control, or VSA System Description - VSA OFF MODE, or VSA System Description - TCS Control, or VSA System Description - Engine Drag Torque Control, or VSA System Description - System Diagram, or VSA System Description - Hill Start Assist Control, or VSA System Description - Overview .
- When the VSA Maintenance Mode is activated, the VSA and TCS functions are disabled.
- During the Maintenance Mode, the VSA OFF indicator flashes and the VSA indicator is on. When the power is switched to OFF Mode or the VSA OFF switch is pressed again, the Maintenance Mode is cancelled and both indicators go off.
- In cases where following events occur, turn the power switch off, wait 10 seconds or longer and retry the procedure.
- The procedure required to enter VSA Maintenance Mode is not followed properly.
- The procedure is not completed within 30 seconds.
- To terminate the maintenance mode, do the either one of the following procedures.
- -1.
Turn the vehicle to the OFF (LOCK) mode.
- -2.
Press VSA OFF switch for 0.5 sec. (make sure VSA indicator and VSA OFF indicator go off).
- -1.
- When the VSA detects a malfunction, the Maintenance Mode is cancelled.
1. Turn the vehicle to the ON mode and do the following procedure within 30 seconds
2. Release the parking brake pedal and hold down the brake pedal. While holding down the brake pedal, press the VSA OFF switch. If the VSA OFF indicator turns on, press the VSA OFF switch again to see if the VSA OFF indicator goes off
3. Release the brake pedal and press the parking brake pedal. While the brake pedal is released, press the VSA OFF switch. If the VSA OFF indicator turns on, press the VSA OFF indicator again to see if the VSA OFF indicator goes off
4. Hold down the brake pedal while press the parking brake pedal. Press the VSA OFF switch while both brakes are applied. If the VSA OFF indicator turns on, press the VSA OFF switch again to see if the VSA OFF indicator flashes and the VSA indicator turns on.