DTC P0777 (CVT)

DTC P0777  : CVT Driven Pulley Pressure Control Solenoid Valve Stuck ON

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (CVT)

1. Transmission Fluid (HCF-2) check

   -1. Start the engine, and warm it up to normal operating temperature (the radiator fan comes on twice).

   -2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.

   -3. Drain the transmission fluid (HCF-2) through a strainer. Inspect the strainer for metal debris or excessive clutch material.

   Does the strainer have metal debris or excessive clutch material?

   YES 

   Replace the transmission .

   NO 

   Replace the transmission fluid (HCF-2) , then go to step 2.

2. DTC check

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Test-drive the vehicle in D position/mode until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the vehicle. Then accelerate from a stop at full throttle in D position/mode until the vehicle speed reaches 37 mph (60 km/h).

   -4. Turn the engine off. Repeat the test-drive in step 2-3 again.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0777 CVT Driven Pulley Pressure Control Solenoid Valve Stuck ON

   Is DTC P0777 indicated?

   YES 

   The failure is duplicated. Faulty CVT driven pulley pressure control solenoid valve. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.