VTC Oil Control Solenoid Valve Removal, Installation, and Test: Test

VTC Oil Control Solenoid Valve - Test

1. Connect VTC oil control solenoid valve 2P connector terminal No. 1 to the 12 volt battery positive terminal with a jumper wire. Connect VTC oil control solenoid valve 2P connector terminal No. 2 to the 12 volt battery negative terminal with a jumper wire.

Fig 1: VTC Oil Control Solenoid Valve Connector End View

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

2. Measure the clearance of the valve (A). The clearance should be at least 0.134 in (3.4 mm).

If the clearance is as specified, the valve is OK; reinstall it with a new O-ring (B).
If the clearance is not as specified, install a new valve and O-ring.