DTC 2608
DTC 2608 : R-Camera Diag
NOTE:
- Check the vehicle 12 volt battery condition first .
- This navigation DTC sets when NG is indicated in the Rear wide camera diagnosis (the Rear wide camera icon is red in the System Links).
- Before you troubleshoot, make sure to follow the General Troubleshooting Information .
- Check any official Honda service website for more service information about the navigation system.
- Check the connectors for poor connections or loose terminals.
- Problem verification
-1. Clear the hard error codes .
-2. Turn the vehicle to the OFF (LOCK) mode.
-3. Wait for at least 6 seconds.
-4. Check for hard error codes .
Is DTC 2608 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- Determine possible failure area (CAMERA ADPT line, others)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Disconnect the following connector.
Rearview camera 6P connector -3. Turn the vehicle to the ON mode.
-4. Measure the voltage between test points 1 and 2.
Test condition Vehicle ON mode Rearview camera 6P connector: disconnected Test point 1 Rearview camera 6P connector No. 2 Test point 2 Body ground Is there about 5.0 V?
YES
The CAMERA ADPT wire is OK. Go to step 4.
NO
Go to step 3.
- Open wire check (CAMERA ADPT line)
-1. Measure the voltage between test points 1 and 2.
Test condition Vehicle ON mode Rearview camera 6P connector: disconnected Test point 1 Audio-navigation unit connector E (36P) No. 16 Test point 2 Body ground Is there about 5.0 V?
YES
Repair an open in the wire.
NO
- Rearview camera check
-1. Substitute a known-good rearview camera .
-2. Reconnect all the connectors.
-3. Turn the vehicle to the ON mode.
-4. Clear the hard error codes .
-5. Turn the vehicle to the OFF (LOCK) mode then the ON mode.
-6. Check for hard error codes .
Is DTC 2608 indicated?
YES
Replace the audio-navigation unit .
NO
Replace the original rearview camera.