FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › Engine Mechanical › Engine Exhaust › Repair Instructions › Exhaust Heat Shield Replacement - Dash Panel › Installation Procedure

Installation Procedure

    Fig 1: View Of Left Exhaust Heat Shield & Nuts
    GM707396Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the exhaust heat shield to the dash panel studs (1), (3).
  2. Install the exhaust heat shield nuts.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Install the engine protection shield and bolts. Refer to ENGINE PROTECTION SHIELD REPLACEMENT .

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  4. Lower the vehicle.
About FixVault