FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › External Pages › Different car › Section 11 (Engine Controls - Self-Diagnostics - 3.5L) › Diagnostic Tests › DTC P0601: Control Module Read Only Memory › Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Replace PCM. Program replacement PCM. See PROGRAMMING .
  3. Using scan tool, to clear DTCs. Turn ignition off and wait 30 seconds. Start engine. Operate vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step  2.
  4. Using scan tool, observe the stored information, Capture Info. Does scan tool display any DTCs that you have not diagnosed? If yes, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
About FixVault