Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wiring Harness & Headlamp

Courtesy of GENERAL MOTORS CORP.

Open the hood.
Connect the wiring harness.
Install the headlamp.
Ensure the alignment pin (4) is positioned to the housing (2).

Fig 2: Retaining Nuts & Connecting Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the retaining nuts (3).
Tighten: Tighten the nuts to 6 N.m (53 lb in).
Connect the electrical connector (4) to the headlamp bulb socket.
Close the hood.
Install the grille. Refer to Grille Replacement in Exterior Trim.