FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › External Pages › Different car › Section 593 (Body Rear End) › Repair Instructions › Liftgate Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Transfer components, as necessary, from liftgate being replaced to liftgate being installed.
  2. With the aid of an assistant, install the liftgate to the vehicle.
    3. Fig 1: Identifying Liftgate
    GM832253Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts (1) that retain the liftgate to the liftgate hinge.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  4. Install the liftgate struts. Refer to Strut Replacement - Liftgate  .
  5. Connect the wiper washer hose.
  6. Install the wiring harness to the liftgate. Refer to Wiring Harness Replacement - Liftgate  .
  7. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate  .
About FixVault