FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › External Pages › Different car › Section 595 (Frame And Underbody) › Repair Instructions › Transmission Support Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Support
    GM794684Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission support to the frame.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Ensure that the transmission support fasteners do not overlap before and after final tightening.
  2. Install the bolts and the nuts in order to retain the transmission support to the frame.

    Tighten:  Tighten the nuts to 95 N.m (70 lb ft).

  3. Lower the transmission.
    4. Fig 2: Identifying Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.
  4. Align the transmission mount with the transmission support.
  5. Install the nuts to the transmission mount.

    Tighten:  Tighten the nuts to 40 N.m (30 lb ft).

  6. Remove the stand or jack.
  7. Lower the vehicle.
About FixVault