FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › External Pages › Different car › Section 657 (Body Front End) › Repair Instructions › Hood Latch Replacement - Left › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cable Sheath Grommet At Latch
    GM71291Courtesy of GENERAL MOTORS CORP.
  1. Install the cable end into the catch on the latch.
  2. Install the cable sheath grommet into the slotted hole in the latch.
    3. Fig 2: Left Hood Latch & Bolts
    GM71288Courtesy of GENERAL MOTORS CORP.
  3. Install the hood latch and attaching bolts.
  4. Align the latch within the marked area.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the hood latch bolts.

    Tighten:  Tighten the hood latch bolts to 10 N.m (89 lb in).

  6. Install the cable sheath to the push-in retainer.
    7. Fig 3: Air Inlet Grille Panel
    GM71294Courtesy of GENERAL MOTORS CORP.
  7. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement  .
About FixVault