FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › External Pages › Different car › Section 916 (Engine Controls And Fuel - 2.4L - Introduction) › Repair Instructions › Ignition Coil Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Coils
    GM1578474Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil(s).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ignition coil bolt(s).

    Tighten:  Tighten the bolt(s) to 10 N.m (89 lb in).

    3. Fig 2: Identifying Engine Wiring Harness Electrical Connectors
    GM1811485Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s).
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
About FixVault