FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › Restraints › Restraints Control Systems › Supplemental Inflatable Restraint System Deactivation Procedures › CHRYSLER › System Operation Check › Except Sebring Coupe & Stratus Coupe

Except Sebring Coupe & Stratus Coupe

CAUTION: When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. If driveability problems exist, see appropriate computer relearn service information.
  1. Connect DRB-III scan tool, or equivalent, to Data Link Connector (DLC). DLC is located on the driver side lower edge of the instrument panel near steering column. Ensure latest version of DRB-III scan tool software cartridge is being used.
  2. Turn ignition switch to ON position, with engine off. Exit vehicle with DRB-III scan tool. Ensure no one is inside vehicle, then reconnect negative battery cable.
  3. Using DRB-III scan tool, read and record any active (current) or stored (historical) Diagnostic Trouble Codes (DTCs). Using DRB-III, erase all stored DTCs. If an problems exists, DTCs will not erase. If DTCs are found, perform diagnosis and repairs as necessary. If all DTCs are erased, go to next step.
  4. From outside of the vehicle, and away from air bags, turn ignition off for about 15 seconds, then back to ON position. Observe AIR BAG warning light.
  5. AIR BAG warning light should come on for about 6-8 seconds, then go out, indicating system is functioning properly. If AIR BAG warning light either fails to come on, blinks on and off, or comes on and stays on, a system malfunction exists. Diagnosis and repair air bag system as necessary.
About FixVault