FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Steering Gear Housing End Plug Replacement - Off Vehicle › Assembly Procedure

Assembly Procedure

    Fig 1: Steering Gear Housing End Plug Assembly
    GM322010Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal (3) with power steering fluid.
  2. Install the O-ring seal (3) into the steering gear housing (5).
  3. Install the plug (2).
  4. Install the retaining ring (1). Ensure that the retaining ring open end is approximately 25 mm (1 in) from the access hole in the steering gear housing (5).
About FixVault