FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Steering Column Tilt Head Housing Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Steering Shaft
    GM667564Courtesy of GENERAL MOTORS CORP.
  1. Install the steering shaft (1) into the steering column tilt head assembly.
    2. Fig 2: View Of Upper Steering Column Components
    GM420224Courtesy of GENERAL MOTORS CORP.
  2. Install the steering shaft (3) into the steering column tilt head assembly (1).

    Install the tilt head assembly (1) and the steering shaft (3) into the steering column jacket assembly (2).

    3. IMPORTANT: The steering wheel lock shoes teeth must be resting on the bar in the steering column jacket assembly.
  3. Align the steering column tilt head assembly with the pivot pin holes on the steering column jacket assembly.
    4. Fig 3: Identifying Pivot Pin Locations
    GM420225Courtesy of GENERAL MOTORS CORP.
  4. Lubricate the pivot pins with GM P/N 12346293 (Canadian P/N 992723).

    Install the 2 pivot pins into the steering column support assembly.

  5. Stake the pins in 3 places.
  6. Install the tilt spring assembly only. Refer to Tilt Spring Replacement .
  7. Install the turn signal switch housing only.
  8. Install the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
  9. Install the ignition lock cylinder case assembly. Refer to Ignition Lock Cylinder Case Replacement .
  10. Install the steering column to the vehicle. Refer to Steering Column Replacement .
  11. Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling Zone 3 .
About FixVault