FixVault
Home › Hummer › 2003 › H2 › Repair and Diagnosis › Steering › Steering Linkage (Non-Rack & Pinion) › Repair Instructions › Tie Rod Replacement - Outer › Removal Procedure

Removal Procedure

IMPORTANT: Use the J 24319-B  in order to separate all the tie rods and ball joints. See Special Tools .
    Fig 1: Loosening Jam Nut On Tie Rod
    GM793269Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the nut from the outer tie rod ball stud (2).

    Do not reuse the nut.

    3. Fig 2: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  3. Use the J 24319-B  in order to remove the outer tie rod ball stud from the steering knuckle. See Special Tools .
    4. Fig 3: Loosening Jam Nut On Tie Rod
    GM793269Courtesy of GENERAL MOTORS CORP.
  4. Loosen the jam nut (1).
  5. Separate the outer tie rod end from the inner tie rod.
  6. Inspect the shaft for bent or damaged threads.
  7. Clean the tapered surface of the steering knuckle.
About FixVault