Installation Procedure

Fig 1: Installing New Internal Speed Sensor Rotor Over Output Shaft Splines

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not reuse an internal speed sensor rotor that has been removed.

Slip a new internal speed sensor rotor (699) over the output shaft splines.
Install the J 36352-4 in the groove on the output shaft (687).
Place the J 36352-6 on the output shaft (687). Press on the J 36352-6 until it contacts the J 36352-4 in the window (the J 36352-4 will be a positive stop for the J 36352-6 ).