FixVault
Home › Hummer › 2004 › H2 4D Utility Pickup › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Generator Cable Replacement › Removal Procedure

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
    Fig 1: View Of Negative Battery Cable At Battery
    GM832902Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) .
    2. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  2. Remove the generator cable from the generator, perform the following:
    1. Reposition the boot to expose the stud.
    2. Remove the generator cable nut.
    3. Remove the generator cable from the stud.
    3. Fig 3: View Of Battery Cables At Junction Block
    GM662521Courtesy of GENERAL MOTORS CORP.
  3. Open the positive cable junction block.
  4. Remove the generator cable nut.
  5. Remove the generator cable (2) from the junction block.
About FixVault