FixVault
Home › Hummer › 2004 › H2 4D Utility Pickup › Repair and Diagnosis › External Pages › Different car › Section 738 (Power Steering System) › Repair Instructions › Power Steering Pump Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pulley. Refer to Power Steering Pulley Replacement .
  2. Place a drain pan under the pump.
  3. Remove the hose guide bracket from the front of the pump.
  4. Remove the hoses from the pump.
  5. Remove the bolt retaining the rear bracket to the engine.
    6. Fig 1: Installing The Power Steering Pump (4.8L, 5.3L and 6.0L)
    GM346660Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts from the front of the pump.
  7. Remove the pump from the vehicle.
    8. Fig 2: Bracket & Power Steering Pump
    GM656325Courtesy of GENERAL MOTORS CORP.
  8. Remove the bracket (3) from the rear of the pump (1).
About FixVault