FixVault
Home › Hummer › 2005 › H2 4D Utility Pickup › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction › Repair Instructions › Evaporative Emission (EVAP) Canister Replacement › Installation Procedure

Installation Procedure

    Fig 1: Chassis Fuel Feed Hose & Fuel Filter
    GM832909Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister to the vehicle.
  2. Connect EVAP solenoid electrical connector.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EVAP canister mounting bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: Vent Pipe & EVAP Canister Vent Valve Electrical Connector
    GM832914Courtesy of GENERAL MOTORS CORP.
  4. Connect the pipes to the EVAP canister.
  5. Lower the vehicle.
About FixVault