FixVault
Home › Hummer › 2005 › H2 4D Utility Pickup › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction › Repair Instructions › Fuel Filler Hose Replacement › Installation Procedure

Installation Procedure

    Fig 1: Fuel Fill Hose & Hose Clamps
    GM832912Courtesy of GENERAL MOTORS CORP.
  1. Uncap the fuel tank opening.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the fuel fill hose and the hose clamps to the fuel fill pipe.

    Tighten:  Tighten the hose clamps to 2.5 N.m (22 lb in).

  3. Lower the vehicle.
  4. Refill the fuel system.
About FixVault