Installation Procedure

Fig 1: Outer Tie Rod Ball Stud & Nut

Courtesy of GENERAL MOTORS CORP.

Lubricate the tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.
Install the outer tie rod end (1) to the inner tie rod.
Install the outer tie rod ball stud (2) to the steering knuckle.

Fig 2: Seating The Idler Arm Tapers

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Use the J 29193 in order to install the outer tie rod ball stud. See Special Tools .
Tighten: Tighten the J 29193 to 54 N.m (40 lb ft) in order to seat the tapers.

Fig 3: Outer Tie Rod Ball Stud & Nut

Courtesy of GENERAL MOTORS CORP.

Install the new prevailing torque nut to the outer rod ball stud (2).
Tighten: Tighten the new prevailing torque nut to 60 N.m (44 lb ft).
Verify the front toe setting. Refer to Wheel Alignment Specifications in Wheel Alignment.
Tighten the jam nut.
Tighten: Tighten the jam nut to 68 N.m (50 lb ft).