FixVault
Home › Hummer › 2006 › H2 4D Utility Pickup › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Ignition Lock Cylinder Replacement › Installation Procedure

Installation Procedure

    Fig 1: View of Ignition Cylinder Lock, Ignition Lock Cylinder Case Assembly and Upper Steering Column
    GM375309Courtesy of GENERAL MOTORS CORP.
  1. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Install the ignition lock cylinder by performing the following procedure:
    1. Align the positioning locking tab slot on the ignition lock cylinder case to the positioning tab on the ignition lock cylinder.
    2. Push the lock cylinder in until the tab locks in the ignition lock cylinder case.
  3. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  5. Perform the Passlock learn procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
About FixVault