FixVault
Home › Hummer › 2006 › H2 4D Utility Pickup › Repair and Diagnosis › Steering › Steering Column › Steering Wheel And Column › Repair Instructions › Ignition and Start Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: Ignition Switch, Electronic Lock Module & J 42759
    GM664261Courtesy of GENERAL MOTORS CORP.
  1. Insert into the ignition lock cylinder case assembly (1).
  2. Connect the connector to the ignition switch assembly (2).
    3. Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
    CAUTION: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
  3. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
  4. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
  5. Install the wires back into the ignition switch clip.
  6. Install the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  7. If equipped, install the theft deterrent control module.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
About FixVault