Installation Procedure

IMPORTANT: The threads must be clean prior to the Loctite® application. Check the Loctite®, or equivalent, container for expiration date. Use only enough Loctite® to evenly coat the threads.

Fig 1: Rack And Inner Tie Rod Threads

Courtesy of GENERAL MOTORS CORP.

Apply Loctite® 262, or equivalent, to the inner tie rod threads (2).
Install the inner tie rod (3) to the rack and pinion (1).

Fig 2: Tightening The Inner Tie Rod

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install a torque wrench (5) to the J 34028 to tighten the inner tie rod (6). See Special Tools .
Hold the rack while tightening the tie rod as shown.

Tighten: Tighten the inner tie rod to 88 N.m (65 lb ft).

Fig 3: Inner Tie Rod Staking Location

Courtesy of GENERAL MOTORS CORP.

Stake the inner tie rod (2) at the location (1) with a hammer and punch.
Install the rack and pinion boot. Refer to Rack and Pinion Boot Replacement - On Vehicle .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Check the wheel alignment. Refer to Measuring Wheel Alignment .