FixVault
Home › Hummer › 2006 › H3 Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls - 3.5L - Introduction (2 Of 2) › Repair Instructions › Fuel Filler Hose Replacement › Removal Procedure

Removal Procedure

  1. Partially drain the fuel tank below the level of the fuel fill tube. Refer to Fuel Tank Draining Procedure .
  2. Raise and support the vehicle, high enough to access the fuel fill hose through the wheelhouse liner. Refer to Lifting and Jacking the Vehicle .
  3. Remove the left rear wheelhouse liner. Refer to Wheelhouse Panel Replacement .
  4. Remove the left rear wheelhouse flare. Refer to Wheel Opening Flare Replacement - Rear (Wheelhouse) or Wheel Opening Flare Replacement - Rear (Door Side) .
    5. Fig 1: Fuel Fill Hose Ground Strap
    GM1560098Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt securing the fuel fill hose ground strap to the frame.
    6. Fig 2: Quick Connect At Evaporative Emission (EVAP) Canister.
    GM1560077Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the fuel fill pipe vent line quick connect (1) from the evaporative emission (EVAP) canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    7. Fig 3: Fuel Tank Connections
    GM1560072Courtesy of GENERAL MOTORS CORP.
  7. Loosen the fuel fill pipe clamp (3).
  8. Remove the fuel fill hose from the fuel tank.
  9. Disconnect the fuel tank vent line (5) from the fuel fill pipe vent line (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    10. Fig 4: Removing/Installing Fuel Fill Pipe
    GM1560101Courtesy of GENERAL MOTORS CORP.
  10. Remove the fuel fill pipe bracket nuts.
  11. Remove the fuel fill pipe from the vehicle.
  12. Cap the open end of the fuel tank.
About FixVault