FixVault
Home › Hummer › 2007 › H2 4D Utility Pickup › Repair and Diagnosis › Body & Frame › Door Locks › Vehicle Access › Repair Instructions › Endgate Handle Replacement › Installation Procedure

Installation Procedure

    Fig 1: Endgate Handle
    GM1412522Courtesy of GENERAL MOTORS CORP.
  1. Position the handle to the endgate.
  2. Loosely install the fasteners.
    3. Fig 2: Lock Rod Retaining Clips
    GM1428164Courtesy of GENERAL MOTORS CORP.
  3. Connect the lock rods (1, 3) to the handle assembly (2).
    4. NOTE: Refer to Fastener Notice .
  4. Connect the lock rod clips (4, 5).

    Tighten:  Tighten the endgate handle bolts to 25 N.m (18 lb ft).

    5. Fig 3: Endgate Trim Bezel
    GM1412524Courtesy of GENERAL MOTORS CORP.
  5. Secure the trim panel bezel to the endgate. Lift the handle slightly to assist in bezel installation.
  6. Secure the bezel clips.
  7. Close the endgate.
  8. Latch and secure the spare tire carrier.
About FixVault