FixVault
Home › Hummer › 2007 › H2 4D Utility Pickup › Repair and Diagnosis › Body & Frame › Door Locks › Vehicle Access › Repair Instructions › Liftgate Lock Actuator Replacement › Installation Procedure

Installation Procedure

    Fig 1: Liftgate Lock Actuator
    GM832256Courtesy of GENERAL MOTORS CORP.
  1. Align the tabs on the actuator to the grooves (3) on the control assembly plate, and slide the actuator down into position.
    2. NOTE: Refer to Fastener Notice .
  2. Install fastener (2) retaining the actuator to the control assembly plate.
    3. IMPORTANT: Install the control arm in the position noted during removal.
  3. Install fastener (1) retaining the control arm to the actuator.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

  4. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

About FixVault