Installation Procedures

Fig 1: Liftgate Lock Plate & Rod

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Position the lock plate assembly in place on the liftgate, and install the fasteners (1) retaining the control assembly to the liftgate.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
Connect the latch control cables (2) to the control assembly by placing the cable ends in their cups and securing the retainers. Note the proper routing.
Connect the lock actuator electrical connector.
Inspect for proper operation.
Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .