Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Position the assist handle over the retaining clips.

Fig 1: View Of Assist Handle & Screw

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the assist handle by installing 2 screws and washers into the retaining clips.
Tighten: Tighten the assist handle screws to 1.2 N.m (10 lb in).

Fig 2: Installing Coat Hook Assembly

Courtesy of GENERAL MOTORS CORP.

In replacing the entire coat hook assembly, press the coat hook and the retaining clip as an assembly into the sheet metal opening until the clip locks into position.